Can not GHOST system reasons and solutions summary

1, a brand machine GHOST XP installation failed: use the partition software PQ to go and see. . It turns out that there is a small partition, which is definitely not GHOST. Because the GHOST installation is on the first partition, and the first partition is only a few megabytes, the file is larger than the space. Of course, this is just a possibility.

GHOST installation failure analysis: GHOST failure on the old machine is divided into several types:
(1) optical drive read capacity is too poor.
(2) The disc itself is too flowery.
(3) The hard disk has bad sectors.
(4) There is a problem with the memory.
(5) Motherboard (this situation is relatively small, generally the first few more, sorted according to the probability of occurrence)

Solution: 1 manual GHOST, 2 re-partitioning and installation (note the data) (3) Install with the GHOST tool of the XP interface in WINPE.

2. The encryption of the hard disk itself cannot cause the system to be installed.

Solution: Use the erase command ERASE in MHDD to perform the partition installation after erasing. Note: This method is very toxic, but also pay attention to the data.

3, other reasons can not be installed solution:

(1) Install with WINPE, this is used after the GHOST installation failed.
(2) Remove the hard disk to other machines GHOST, do not install after the clone is completed, then connect the hard disk back to the original machine, recognize it once.
(3) using a USB flash drive or mobile hard disk to install the system, this method can avoid a lot of GHOST failure, or without the optical drive, it is more suitable for netbooks and small books without optical drive.

4, new books can not GHOST installation XP solution

Solution: blue screen during installation, error phenomenon: blue screen prompt code The last few are:
TECHNICAL INFORMATION
STOP: 0X0000007B

The reason for this is that the new notebook has been added to an advanced hard drive mode. The solution is very simple. Find the ONCHIP SATA TYPEP in the BIOS - "NATIVE IDE -" to change the AHCI to IDE to solve the problem. Of course you have to find this option. . Different BIOS locations may be different. Anyway, I will find it slowly. . Find the option to find the SATA word. The last item must be the same. (Note. If you want to let people who don't understand install this system again, you can go back to the BIOS and change it back after GHOST is completed. Of course, this is my own experiment with my own books. If not, change it. Come back, you can't help me (^**^).